|
|
|
 |
4B11 CAMSHAFTS
The 4B11T is the first engine in the Lancer Evolution series that uses a die-cast aluminum cylinder block versus the cast-iron block used in the previous turbocharged 4G63 engine that powered all previous models. The engine weight has been reduced by 26 lbs compared to the 4G63, even with the addition of a timing chain instead of a belt and MIVEC continuous variable valve timing on both the intake and exhaust camshafts (the 4G63 had MIVEC valve timing & lift switching type on the intake only). A revised turbocharger offers up to 20-percent quicker response at lower engine speeds compared to previous 4G63. The 4B11T offers a broader torque curve, producing more torque than the 4G63 at all engine speeds, helped by the engine's square bore and stroke design (both measure 86.0 mm). Redline starts at 7,000 rpm, with a fuel cutout at 7,600 rpm to protect the engine. A semi-closed deck structure, an integrated ladder frame and four-bolt main bearing caps contribute to engine strength and durability. Unlike the 4G63, the 4B11T does not use a balancer shaft. Aluminium is used for the timing chain case and cylinder head cover. The engine features an electronically controlled throttle, an isometric short port aluminum intake manifold and the stainless steel exhaust manifold is positioned at the rear of the engine. The use of a direct-acting valvetrain (buckets) eliminates the need of the roller rocker arm configuration previously used in the 4G63 and its valve stem seals are integrated with the spring seats. |
 |
|
Stage |
|
Description |
|
Part# |
|
Adv. Dur. |
|
Dur @ .050 |
|
Lift (in) |
|
Lift (mm) |
|
Kit# |
|
Cam Card |
|
Dyno |
|
Shop |
|
Status |
|
|
 |
Track/Strip Specification
Plug and play application. Short duration for nice track manners, slight lope at idle. Excellent all purpose spec. OEM spring OK. |
BC0131 |
272°/272° |
234°/223° |
.445"/.419" |
11.30/10.64 |
BC0130 |
 |
 |
 |
In-Stock |
|
 |
Race Specification
Longer duration profile, added rpm potential. Intended for fully built engine. Tuning and ECU mods recommended. Requires kit BC0130. |
BC0132 |
280°/280° |
240°/234° |
.459"/.445" |
11.94/10.64 |
BC0130 |
|
|
|
In-Stock |
|
|
 |
USDM 4B11T (Evolution X) |
Stock |
248°/248° |
221°/193° |
.382"/.338" |
9.70/8.58 |
|
|
|
|
| Note: Due to the high lift of these camshafts, you must check retainer to valve guide clearence. |
|
|
619.749.9018 ph
619.749.9128 fx
|
| Some products listed are not legal for sale or use on emission controlled motor vehicles, RPM ranges vary on application.Warranty Information Copyright © Brian Crower Inc. All rights reserved.. |
|
|
 |
WARNING: This product can expose you to chemicals,
including Chromium (hexavalent compounds), lead and lead
compounds, which are known to the State of California to
cause cancer, birth defects or other reproductive harm. For
more information, visit www.p65warnings.ca.gov |
|
 |
|
|
|
